Aluminum Parts Chassis LOGO 200

Ball Bearing Main Rotor Shaft LOGO 200

Battery Plate Set LOGO 200

Battery RC Mounting Plate Logo 200

Bearing/Damper Set Rotor Head LOGO 200

Blade Holder Rotor Head LOGO 200

Blade Holder Rotor Head Screws LOGO 200

Canopy holder LOGO 200

Canopy LOGO 200 neon-yellow/blue/black

Carbon Sideframes right+left LOGO 200

Carbon Vertical Fin, LOGO 200

ESC Case, LOGO 200

ESC Control Board, LOGO 200

Landing Skids LOGO 200

Linkage Set Rotor Head LOGO 200

Linkage-Set Swashplate LOGO 200, to be used for Mikado and OMp helicopters

Lipo Battery 11,1V, 3S-650mAh, LOGO 200

3 adapters per pack

Hardware Features of the Current/Voltage/Capacity Sensor for flight packs

• Plug & play version with XT30 connectors and sensor wire, perfect fit for LOGO 200
• No influence from motor or current carrying wires
• Sensor wire attached

Software Features

• Direct displaying from voltage and capacity
• Max. current and min. voltage storage
• Log file data from the flight
• Battery Logbook with names
• Adjustable capacity, residual capacity and voltage for each battery
• Residual capacity is shown as bar in the radio display
• Over discharge Warning
• Warning at use of not fully charged batteries
• Loud speaker announcement for reducing battery capacity

Notes

• Requires a VBar with Spektrum Satellite connectors (telemetry bus for VBar Control)
• extracted capacities are not added up, measurement only on a per-flight basis

Motor Main Rotor, LOGO 200

Motor Tail Rotor, LOGO 200

Replacement set of four OMP Hobby 3x6x2.5mm Bearings. Set of 4, fits Also Mikado logo 200

Replacement set of three OMP Hobby Battery Trays, suited for use with the OMP M2 V2 and Explore helicopters.

This is a replacement set of two OMP Hobby Feathering Shafts, suited for use with the OMP M2 V2 and Explore helicopters. Includes replacement hardware.

Set of 2 shafts, hardware

Replacement set of fourOOMP Hobby Flanged Bearings  2x5x2.5mm MF52ZZ

This is a replacement OMP Hobby Head Button, suited for use with the OMP Hobby M2 V2 helicopter. Compatible ONLY with OSHM2001

This is a replacement OMP Hobby M2 Canopy – Orange OSHM2040

This is a replacement package of OMP Hobby Main Rotor Blade Grip Hardware, suited for use with the OMP Hobby M2 V2 helicopter. Specifically this package is for the aluminum blade grips found on the V2, but of course the metal grips can be used as an upgrade to the plastic alternates.

Replacement OMP Hobby Middle Reinforcement Plate Frame, suited for use with the OMP M2 V2 and Explore helicopters.

Satellite Receiver adapter futaba (3 PCS)

Servo Swing Arm (6 pcs)

OMPHOBBY M2 Canopy Mounting Bolt Set : OSHM2115

Model compatibility: M2 / Exp

OMPHOBBY M2 Explore Anti Rotation Guide