Robbe-Schluter

BALL HEAD 3MM M2,5 2PCS

BALL LINK 8MM

Motor BEARING BRACKET 30X30 MONT.

Specially made for Robbe helicopters, This is set needed to replace all possible bearings.
Cost economic (50+% less then if purchased separately)

Included
S4035 (3x8x3) x 8
S4303 (5x13x4) x 2
S0211 (10x22x6) x 2
S0212 (8x16x5) x 2
S3367 (4X10X4) x 4
S1551( TRUST) X 2
S4287 (8X19) X 2
S3364( TRUST) X 2
S4299( 7X14) X 2

Aluminium bellcrank conversion set for all versions of the , Cuatro, Dyna-x,Futura and the Millennium, and gives your helicopter an improved appearance as well as a more direct swashplate linkage.
Contains- 4 alu bellcranks+ metal balls,

Ball bearings and washers can be reused from the plastic set.
Optional  8 bearings (3x8x3) + shims can be purchased

Aluminium bellcrank conversion set for all versions of the , Cuatro, Dyna-x,Futura and the Millennium, and gives your helicopter an improved appearance as well as a more direct swashplate linkage.
Contains- 4 alu bellcranks+ metal balls,

Ball bearings and washers can be reused from the plastic set.
Optional  8 bearings (3x8x3) + shims can be purchased

BALL, BRASS 10PCS

CANOPY MOUNT .2 PCS.

Canopy Rubbers Robbe( fit other models) 4pcs

CFK plate Spirit LI, to Allow lipo mounting between the skids

CLAMPING RING D10 AL BLACK

Clutch bell Robbe Millenium, Nova, futura

CNC tail Metal Gearbox for Robbe, fits Millenium60-90, Futura nova( 24mm) , Cuatro.

• Anodized in Natural color.
• Fits 24mm booms, with special CNC made smoother gear.
• Ratio- 1:1  
• This gearbox is Lighter then stock plastic gearbox
• Beautiful and strong 1 piece design. Set complete with Ball bearings, Hardware, and pinions
• Can be mounted Left or Right side.
• Double Tail scissor arm set included with the gearbox ( 64 eur value )
• Note:Tail Output Shaft and Plastic
• Tail Bridge S1038 are not included in the kit!

This gearbox and all parts of it are produced in Europe.From now this is the most affordable and best gearbox

COLLET 5 MM

CONTROL LEVEL F. SHEAR TAIL ROTOR

CONTROL LEVER WITH BALL, 2 PCS

CONTROL SLEEVE (2XM2)

Dowel Brass 6pc.

Double Ball Bearing start system set including : Clutch bell, special Hardened Pinion , choice of 14-15-16T ( one pinion per set) , Ball Bearings, start block and hardware are included in a set, and those are a direct replacement for Millenium 2 / 3 and Dyna-X start system. Reduces movement of the Pinion during Extreme 3D, and protecting the pinion from been exposed to dust. Anodized in Clear.

New Design, with beautifull logos of Dyna-XA4 size

One large X brace

One Small X brace