Mikado

Tailboom D22x690mm LOGO 500 SE

Tailboom LOGO 400, 2 PCS

 Tailboom LOGO 400 SE - 520mm

Tail boom dia. 25x755 mm, LOGO 600-3D

Threaded rod canopy attachment LOGO 10-3D

Threaded rod M3x45

Thrust bearing 4x8x3,5, Set of 2 bearings

 

Thrust bearing 5x10x4,Set of 2 bearings

Thrust bearing 6x14x5

Includes:

• 1 bearing set(3 pcs trust)

Thrust bearing 8x16x5, Set of 2 bearings

Thrust bearing for rotor head, LOGO XXTreme 800

Thrust bearing rotor head LOGO XXTreme 700  & 800 (2pcs)

Torque Tube with bearings, LOGO 700 XXtreme

Trust Ball bearing 4x8x2 2pcs

Upgrade Rotor Head LOGO 20/24

Upper Carbon Chassis Frames 1mm, LOGO 700 XXtreme

Upper Carbon Chassis Frames, LOGO XXtreme 800

Upper Chassis Frame, LOGO 200

Upper Chassis Frames 1,5mm, LOGO 700 XXtreme

Upper Main Rotor Shaft Support, LOGO XXtreme 700 & 800

 Upper stiffening plate 1mm, LOGO 700 XXtreme

Vbar Control 3-Position TX switch Long version

Vbar Control 3-Position TX switch Short version

VBar Control fast charger

VBar Control lanyard

VBar Control lanyard RED

Vbar Control Potentiometer with Black cap, replacement item Vbar

Vbar Control Potentiometer with Black cap, replacement item Vbar

VBar Control RX-Satellite Connection Wire, 120mm

VBar Control RX-Satellite Connection Wire, 200mm

VBar Control TX Rotary knobs colored

VBar Control/Scorpion ESC-Cable 350mm

VBar Control/Scorpion ESC-Cable 500mm

VBar mainboard blueline .
The new VBar Blueline mainboard is downward compatible with all existing main units (except for VBar with aluminium case sensor).

Case for VBar NEO including 180 mm 2.4 GHz antenna wires

For the 2nd hardware generation
04945/46 VBar NEO 6.1 Express (with antenna connectors on the main board)

VBar NEOs of the 1st hardware generation can not be converted.
For those devices, please use VBar Control RX Satellite 04882 and connecting cable 04977.

You can identify devices of the 2nd generation in 'My Devices' at www.vstab.info/devices, by the addition of (no VLink) or (VLink).
Devices of the 1st generation do not yet have that addition yet.
The change took place around serial no. 20007500, from here on please check for the addition and the internals (s. above).
To enable the receiver function, please purchase the Crossgrade from our App Store, which you can access through the VBar Control Manager, with the device connected and powered up (boot plug must be present).
If the Crossgrade is not available for your device, you have a device which can not be converted.
Also, you can buy the Crossgrade for (no VLink) devices only, so you can not accidentally purchase it for a device which already is VLink.

Vertical Carbon Chassis Frames, LOGO XXtreme 800