Mikado

Pinion 18 teeth Ø5mm, module 0,7

Pinion 19 teeth dia.5mm, module 0,5 

For LOGo 10, 400

Pinion 20 teeth D5mm, module 0,5

Pinion 21 teeth Ø5mm, module 0,5

Pinion 22 teeth Ø5mm, module 0,5 LOGO 10

Pinion 26 teeth D5mm, M0,5

Pinion 27 teeth Ø5mm, module 0,5 LOGO 10

Pinion 28 teeth dia. 5mm, module 0,5 LOGO 10

Pinion 29 teeth Ø5mm, module 0,5 LOGO 10

Pinion 30 teeth Ø5mm, module 0,5 LOGO 10

Pinion for herringbone gear 13 teeth 25, M1, dia. 6mm

Pinion for herringbone gear 14 teeth 25, M1, dia. 6mm

MIK-4716 Pinion for herringbone gear 16teeth, M1, dia.8mm

Use for:

• Mikado logo Xxtreme 700 and 800

Pinion for herringbone gear 19teeth, M1, dia.8mm

For the Logo 700 / 800 XXtreme

Pins for yoke

Pivot bearing 4x8x3

Pivot bolt M2.5x10 (2 pieces)

Pivot bolt M2.5x6 (2pieces)

Pivot bolt M2.5x8 (2pieces)

Pivot bolt M3x10 swashplate (long), 2pcs

Pivot bolt swashplate M3x8 (short)

Radio Case Faux Leather V-Control with Mikado Logo 200

this Case can fit the Mikado logo 200 And the Vbar control radio

of course Helicopter not included.

Raised head hex screw M4x12

RC/ESC Mounting Frames 1,5mm LOGO 700 XXtreme

 RC/ESC Mounting Frames, 1mm, LOGO 700 XXtreme

RC/ESC Mounting Frames, LOGO XXtreme 800

This is a replacement antenna for Mikado Vbar Antenna for VBar NEO, 180mm #05063

Rotor Blade Holder, LOGO 200

• new one piece yoke
• new counterbearing with mainshaft support
• main shaft for LOGO 600 SE

Important note:

This upgrade set works only in connection with a motor shaft 6mm x 32mm long.

MIK4619 Rotor head yoke one-piece

For the Mikado LOGO 550-600 SX

Please use this yoke only with shorter mainshaft #4620. The swashplate driver arm will be mounted here directly on the yoke.

Rotor head yoke, LOGO 500/600 upgrade set for LOGO helicopter with standard mainshaft (205mm) and separate swashplate driver. Important note: Use only with main shaft #04075 and swashplate driver #04018!

Rudder control guide for 25mm tailboom