Satellite receiver for Duplex R9, R10, R11EPC, R12EPC, R14 and Duplex R18 (connection by cable). PPM output is available on a single line.

The DUPLEX EX line of receivers is intended for operation with DUPLEX Tx transmitter modules in the 2,4GHz band and are fully compatible with the previous version of the DUPLEX. Thanks

to the fully digital and bidirectional communication between

transmitter and receiver there arise completely new aspects in the model

remote control branch. One of the most important advantages is the

operation without crystal, moreover the low susceptibility towards

interference, the high range up to the limit of visibility and the

possibility to follow anytime the onboard state of the model and its

functional parts.
An additional satellite receiver RSat2 complements

the receivers R9, R10, R11, R12, R14 and R18. This receiver is a full

DUPLEX system receiver offering the complete functional spectrum of the

system. Instead of classical servo pulses the output of the RSat2

receiver offers a PPM signal only. This PPM signal is further on

processed by the receivers R9, R10, R11, R12, R14, R18 or by compatible

RC equipment which requires a PPM signal at the input.

DUPLEX EX System is fully compatible with the previous version of the DUPLEX.

Weight [g] 6
Dimensions [mm] 38 x 20 x 7
Number of channels 16
Telemetry Yes
Operational temperature [°C] -10 ... 85
Compatible protocols DUPLEX 2.4GHz EX, EX Bus
Antenna Length [mm] 2 x 200
Supply Voltage [V] 3,2 - 8,4
Average Current [mA] 30
Satellite receiver support No
Output Power [dBm] 15
Receiver Sensitivity [dBm] -106