Car spare parts

Receiver, micro TQ 2.4 GHz with Traxxas Link (5-channel)

ROG TERRA 56T METAL CENTER SPUR GEAR (32 PITCH)

ROG TERRA LEXAN 2MM CLEAR BODY #CA-140.2

ROGUE TERRA STEERING 4 MM ROD END ball link- set of 4

Screw pin, 4x15mm (6)

Servo, micro, waterproof

Shock tower (for rectangular body posts)

Shock tower (front)

Skid plates (front & rear)

Spur gear, 54-tooth (0.8 metric pitch, compatible with 32-pitch) (for Slash 4X4 center differnential)

Spur gear, 58-tooth (0.8 metric pitch)

Spur gear, 90-tooth (48-pitch) (for models with Torque-Control slipper clutch)

Steering arm (upper & lower)/ steering link/ servo horn/ servo saver/ servo saver spring/ servo horn mount/ ball stud (2)/ shock mounts, front & rear/ 2.5x18mm CS (4)

Steering bellcranks/ servo saver/ servo saver spring/ servo spring retainer (requires 5x11mm BB (2))

Steering blocks, Rustler/Stampede/Bandit (2), 6061-T6 aluminum (red-anodized)/ 5x11mm ball bearings (4)

Steering blocks, Rustler/Stampede/Bandit (2), 6061-T6 aluminum (blue-anodized)/ 5x11mm ball bearings (4)

Stub axle + steel yokes (2 pcs assembled)

Suspension arm set, rear (includes upper right & left and lower right & left arms) (1/16 E-Revo)

Suspension arms (upper) (2) (fits all Maxx series)

Suspension arms (front) (2)

Suspension arms, adjustable wheelbase left side (upper arm (1)/ lower arm (1))

Suspension pin set, stainless steel (w/ E-clips)

Toe links, Revo (Tubes 7075-T6 aluminum, black)(128mm, fits front or rear) (2)/ rod ends, rear (4)/ rod ends, front (4)/ wrench (1)

Toe links, aluminum (red-anodized) (4) (assembled with rod ends and threaded inserts) (1/16 E-Revo)

Traxxas 2082 Gear Set for 2080 Micro Waterproof Servo

Traxxas 5800mAh 7.4-volt 2-cell 25C LiPo with iD Auto Battery Identification

Features:

• iD Technology
• Semi rigid construction does not require a hard case and eliminates wire harness connectors that can loosen and fail
• Engineered specifically to fit Traxxas models
• 12AWG multi strand wire is soldered directly to the LiPo cells eliminating increased resistance from bullet connectors and accidental reversed polarity connections

Specifications:

• Measures: 135 mm x 25 mm x 45 mm
• Voltage: 7,4V (2S)
• Capacity: 5800 mAh
• C-rate: 25C

Traxxas Power Cell iD Technology LiPo battery with high current connector.

Requires:

• EZ-Peak Plus 4-amp NiMH/LiPo Fast Charger with iD™ Auto Battery Identification
• LiPo charging bag

Traxxas Ball bearings 5x11x4mm set of 10

Traxxas Ball bearings 5x11x4mm set of 12

Ball bearings (5x11x4mm) (set of 14)

PARALLEL AND SERIES Y-HARNESS WITH TRAXXAS HIGH-CURRENT CONNECTORS Only Traxxas Y-harnesses let you run dual-battery power for increased speed or runtime with the proven convenience and performance of genuine Traxxas High-Current Connector

PARALLEL AND SERIES Y-HARNESS WITH TRAXXAS HIGH-CURRENT CONNECTORS Only Traxxas Y-harnesses let you run dual-battery power for increased speed or runtime with the proven convenience and performance of genuine Traxxas High-Current Connectors

Traxxas set of Ball Bearings 5x11x4mm 6 sets, 5x8x2.5 8 sets

The stock Revoand T-Maxx  driveshafts are already engineered to take tons of abuse with minimal maintenance, but upgrading to Traxxas Steel CV Driveshafts permits even more hardcore action. With superior durability and innovative design, these shafts eliminate the weaknesses that cause other shafts to fail. Both inner and outer U-joints are lubricated and sealed by a rubber boot to protect against the dirt and grime that cause wear. The U-joint pins are held captive by a lightweight aluminum sleeve so you never have to worry about losing a pin. Computer-aided design allows the shafts to handle the extreme articulation generated by Revo and T-Maxx's giant suspension travel. Dogbone plunge over the entire range of suspension travel is kept to the absolute minimum. The ultra performance look is enhanced by the nickel plated steel shafts, blue silicone boots, and red-anodized aluminum accents. Because they are manufactured by Traxxas, you can count on a perfect fit; efficient, smooth running; Traxxas tough durability; and unmatched support. These are simply the most advanced steel CV driveshafts available. Fits T-Maxx models 4902, 4909, and Revo models 5310, 5309.

Traxxas Steering blocks L & R

Sold without bearings 5x11x4mm

VTEC continues to confirm its position as the foremost R/C tyre manufacturer on the market today. Just like its smaller buggy tyre brother, the VTEC 1/8 Truggy “LP” Competition tyres are based on a special compound of high-quality rubber which combines high grip with low tire wear.

The all new Truggy “LP” tyres have been developed through long and extensive testing and are offered in 3 different tread designs with different compound hardness for any tyre of racing situation. High-grip, low-grip, dusty, blue groove, qualifying, long mains, wet, Astroturf or indoor conditions, the VTEC 1/8 Truggy “LP” Competition Tyre Line can do them all!

Truggy LP stands for “Low Profile”. The tyre is specially designed with a lower sidewall for more direct response and higher cornering speed.

U-joints, driveshaft (carrier (4)/ 4.5mm cross pin (4)/ 3mm cross pin (4)/ e-clips (20)) (metal parts for 2 driveshafts)